JRdezigns
Forum Replies Created
-
AuthorPosts
-
MrPaul.
Nope. I haven’t had any issues with the cut surfaces. The laser does a nice job burning the edges…. the edges of my base have chipped a little but these were cut on a table saw and do not seem to do anything to the integrity of the base… o
on another note. I haven’t worked on mine in about a week. I am packing and getting ready to start another quarter of school in Cincinnati. So once I’m all settled in I’ll get all the electronics done and see what happens.
-James-
No they are shorter then listed in the instructions. I have a longer set if the racking becomes an issue. The longer ones cut down on the Y axis cut size so I’m going to give it a try and see what happens. I have some thoughts of adding another set of bearings and vertical wall for them to roll against. Once its up and running I’ll toy around with that.
-James-
Lots of progress. Everything is all together. Just waiting on the transformer and I’ll start soldering everything for the driver board this week. I used the dremel 300 instead of the 395.
Check out the new images
http://www.jrscncbuild.blogspot.com
-James-
Great thanks for the info. I have been talking to my brother (IT guy). He said hes got enough spare parts to build a desktop that can run everything. It would be great though in the future if using a laptop could be possible.
-James-
Just realized I put the Z Cart top on the bottom so ignore that image.
-James-
Made a lot of progress on mine today.. Some new images up on my blog.. Thanks
http://jrscncbuild.blogspot.com/
-James-
Thanks. Feel free to use them.
-James-
What are your opinions on 1/4″ MDF.I ran into the same problem at the local home depot and Lowes…
-James-
-
AuthorPosts