Y-Belt rubbing

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by  Taylor 7 years, 9 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2285

    Bill
    Participant

    I was working on the final mechanical assembly and ran into an issue with the Y-Belt exit holes in both the Vertical Brace Front and Back. They seem to be too high, causing the Y-Belt to rub. I think the centers of these holes should be horizontally aligned with the bottoms of the lower bearing bolts, but they seem to be aligned with the tops, instead.

    #3501

    Taylor
    Keymaster

    Good point! We’ll address that in the next release.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.