Using DIYLILCNC to cut panels for another DIYLILCNC?

DIYLILCNC Builders

Tagged: , , ,

This topic contains 1 reply, has 2 voices, and was last updated by  Chris 6 years, 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 19, 2010 at 5:47 pm #2323

    gjbloom
    Participant

    Does anyone think it would be possible (or likely) that a design could be created to allow one DIYLILCNC to cut the panels needed for a new DIYLILCNC?

    April 20, 2010 at 3:14 pm #3568

    Chris
    Keymaster

    @gjbloom, yes, in theory it would be possible. You’d probably need to extend the Y-axis to allow for the cutting of the x-beams. You’d also have to account for the radius of the cutting bit by blowing out the interior corners of all the cuts, like this.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.