Software?

DIYLILCNC Builders

Tagged: , ,

This topic contains 3 replies, has 3 voices, and was last updated by  Chris 5 years, 9 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 20, 2009 at 3:23 pm #2231

    bill
    Participant

    Neat project. I can’t see any mention of the software you’re using to run the machine. If you’re not already using it, I’d recommend EMC/Axis, available as open software at http://www.linuxcnc.org

    November 20, 2009 at 3:34 pm #3170

    Taylor
    Keymaster

    Funny you should mention it, as EMC is our software of choice. We describe how EMC is used as our controller on pages 61-63 of the project instructions PDF (see Downloads section).

    November 21, 2009 at 3:56 pm #3171

    bill
    Participant

    Excellent. I looked in the forum and various other places, but I didn’t actually download the PDF, because I was under the impression it was just diagrams for cutting out parts. Looks like a pretty cool setup. I hope you have great success with it. :-)

    September 9, 2010 at 6:39 pm #3172

    Chris
    Keymaster

    Please see complete software info in this post: http://diylilcnc.org/forum/topic/software-workflows

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.