Other source for the Wiring Harness

This topic contains 3 replies, has 4 voices, and was last updated by  amigaman 8 years, 10 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #2241

    EqualsP
    Participant

    While researching for other sources for the parts, I found that Monoprice.com is a cheaper source for the Wiring Harness $0.76 each for the 14, Product ID 1316.

    http://www.monoprice.com/products/product.asp?c_id=102&cp_id=10245&cs_id=1024501&p_id=1316&seq=1&format=2

    #3290

    DIYengineer
    Participant

    You could always buy a spool of wire, the clips, and the plastic housing and DIY. I doubt it will be cheaper but the connections might turn out a bit more solid. After 2-3 disconnects on cheaper Pre-fab units the pins like to migrate out which is annoying but easily fixable. If you never or rarely disconnect them no worries.

    But .76 cents each is dirt cheap and tempting!

    #3291

    Taylor
    Keymaster

    Also, keep in mind that the hobbycnc driver kit comes with a length of 6-conductor wire (at least it did when we purchased ours). This can be spliced with the jacks listed above to balance convenience and cost.

    #3292

    amigaman
    Participant

    I found 36″ cables here:

    http://www.pctoys.com/powerext.html

    for $1.95 with free shipping.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.