http://diylilcnc.org/forum/topic/software Free, open-source plans for a low-cost 3-axis CNC mill by Taylor Hokanson and Chris Reilly. Sponsored by the School of the Art Institute of Chicago. en-US Mon, 21 May 2012 15:48:46 +0000 http://bbpress.org/?v=1.0.2 q http://diylilcnc.org/forum/search.php http://diylilcnc.org/forum/topic/software#post-596 Thu, 09 Sep 2010 18:39:01 +0000 Chris 596@http://diylilcnc.org/forum/ <p>Please see complete software info in this post: <a href="http://diylilcnc.org/forum/topic/software-workflows">http://diylilcnc.org/forum/topic/software-workflows</a> </p> http://diylilcnc.org/forum/topic/software#post-79 Sat, 21 Nov 2009 15:56:26 +0000 bill 79@http://diylilcnc.org/forum/ <p>Excellent. I looked in the forum and various other places, but I didn't actually download the PDF, because I was under the impression it was just diagrams for cutting out parts. Looks like a pretty cool setup. I hope you have great success with it. :-) </p> http://diylilcnc.org/forum/topic/software#post-65 Fri, 20 Nov 2009 15:34:14 +0000 Taylor 65@http://diylilcnc.org/forum/ <p>Funny you should mention it, as EMC is our software of choice. We describe how EMC is used as our controller on pages 61-63 of the project instructions PDF (see Downloads section). </p> http://diylilcnc.org/forum/topic/software#post-64 Fri, 20 Nov 2009 15:23:03 +0000 bill 64@http://diylilcnc.org/forum/ <p>Neat project. I can't see any mention of the software you're using to run the machine. If you're not already using it, I'd recommend EMC/Axis, available as open software at <a href="http://www.linuxcnc.org" rel="nofollow">http://www.linuxcnc.org</a> </p>